Billet-specialties Premium Tru Trac Serpentine System - 348__409 Chev Manuel d'utilisateur télécharger pdf (Page 8)

www.billetspecialties.com • Tech Line 708.588.0505

348/409 Chevrolet Tru Trac - 14405 / 14425

Figure 9: Install Crankshaft Pulley

Apply Loctite to the following:

(3) 3/8-24 x 3/4” socket head cap screws

[A] Place the crank pulley on the damper,

thread the three 3/8-24 x 3/4” socket head

screws with bellville washers (cup facing

pulley) through pulley and into damper,

tighten firmly

(46ft/lbs).

Figure 10: Install Water Pump Pulley

Apply Loctite to the following:

(4) 5/16-24 x 3/4” socket head cap screws

[A] Place water pump pulley on water

pump shaft, thread the four 5/16-24 x 3/4”

socket head cap screws through the pulley

and into the water pump flange, tighten

firmly

(28 ft/lbs).

[A] [A]

Cup of washer towards engine >

Figure 11: Install Idler Pulleys

Apply anti-seize to the following:

(3) 3/8-16 x 1-3/4” ARP 12-point cap screws

[A] Install the first pulley by threading the ARP 12-point cap screw through the pulley cover,

pulley and boss into the bridge bracket, tighten firmly (46 ft/lbs).

[B] Install the second idler pulley by following the instructions described in step [A].

[A] [B]

Figure 12: Install Tensioner Pulley & Belt

Route belt as shown below minus tensioner pulley.

Place a 5/8” box end wrench on tensioner, align belt onto grove of tensioner pulley.

[A] Pull box end up/clockwise until tensioner boss lines up with hole in tensioner pulley, slide

pulley onto boss and slowly return wrench to starting position, applying tension to the belt.

Apply anti-seize to the following:

(1) 3/8-16 x 3/4” ARP 12-point cap screw

[B] Thread ARP 12pt. cap screw with aluminum washer

onto tensioner boss and tighten firmly (46 ft/lbs.).

With Power Steering Without Power Steering

[A]

[B]

1 2 3 4 5 6 7 8 9

Pas de commentaire

Billet-specialties Premium Tru Trac Serpentine System - 348__409 Chev Manuel d'utilisateur Page 8