Billet-specialties Tru Trac Serpentine System - Small Block Ford Manuel d'utilisateur télécharger pdf (Page 6)

www.billetspecialties.com • Tech Line 708.588.0505

Small Block Ford Tru Trac - 13605 / 13625

Figure 5: Install Timing Cover & Gasket

Apply a thin film of RTV to back of timing cover and engine block surface.

A] Align and install timing cover gasket to block. Place timing cover over studs

and crank snout.

B] Thread one 5/16-18 x 2-1/4” ARP 12pt. bolt into driver side bottom hole on

timing cover and finger tighten.

Figure 6: Install Factory Timing Marker

A,B] Take factory steel timing marker and install one 5/16-18 x 2-1/4” ARP 12pt.

bolt through bottom hole of timing marker and thread into timing cover.

Thread one 5/16-18 x 2” ARP 12pt. bolt into other hole and finger tighten both

bolts.

C] Thread one 5/16-18 x 2” ARP 12pt. bolt into remaining driver side bottom hole

in timing cover and finger tighten.

If you did not remove the oil pan?

D] Install two 5/16-18 x 1/2" hex head cap screw through the holes nearest the

crankshaft and into the timing cover. Thread the two remaining 1/4-20 x 1/2" hex

head cap screws trough the corner holes of the oil pan into the timing cover.

Make sure corner gaskets line up with holes. Corner gaskets may need to be

trimmed to allow gaskets to sit flush with engine and

timing cover.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Billet-specialties Tru Trac Serpentine System - Small Block Ford Manuel d'utilisateur Page 6