Billet-specialties V-Trac Pulley System - Small Block Chevy Manuel d'utilisateur télécharger pdf (Page 8)

TECH LINE: 708-588-0505 FAX 708-588-7181 www.billetspecialties.com

Figure 5 - Install Alternator & A/C Compressor

Alternator: Apply anti-seize to the threads of the 10mm-1.5 x 80mm ARP 12pt.

cap screw and the 8mm-1.25 x 25mm ARP 12pt. cap screw. Place alternator

between lower bridge bracket and alternator bracket and thread the long

ARP 12pt. cap screw through the bridge bracket, alternator and into the

alternator bracket and finger tighten. 10mm shim washers are provided to

shim the lower alternator boss to the bridge bracket. The alternator boss may

vary in width due to the polishing process. Place the 8mm slide spacer* on

the short ARP 12pt. cap screw, align top alternator boss with bridge bracket

and thread the cap screw with slide spacer through bridge bracket and into

alternator boss and finger tighten.

A/C Compressor: Apply anti-seize to the threads of the 3/8-16 compressor

shoulder bolt and two 8mm-1.25 x 25mm ARP 12pt. cap screws. While

supporting the compressor, place the shoulder bolt and washer into the back

compressor mount boss and align with compressor bracket on motor and

finger tighten. Thread one 8mm ARP 12pt. cap screw through bridge bracket

and into lower compressor boss and finger tighten. Place the 8mm slide

spacer* on the short ARP 12pt. cap screw, align top compressor boss with

bridge bracket and thread the cap screw with slide spacer through bridge

bracket and into compressor boss and finger tighten.

*Flange of spacer fits into

adjustment slot on bracket.

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Billet-specialties V-Trac Pulley System - Small Block Chevy Manuel d'utilisateur Page 8