Billet-specialties Premium Tru Trac Serpentine System - Pontiac Manuel d'utilisateur télécharger pdf (Page 10)

www.billetspecialties.com

Figure 16: Install Compressor Manifold

If you are going to be installing your air conditioning hoses and charging the system at this

time, remove the plate on top of the compressor body and apply anti-seize to the two

8mm-1.25 x 25mm socket head cap screws.

[A,B] Install compressor manifold onto compressor with two 8mm-1.25 x 25mm socket

head cap screws and tighten firmly (13ft/lbs).

Install hoses, connect clutch wire and charge system.

If you are NOT installing hoses and charging the system at this time, place compressor

manifold and hardware in a safe place and leave cover plate on compressor at this time.

Do not connect clutch wire or apply power to clutch wire without the hoses connected

and system charged – Serious damage will occur to compressor.

Compressor Oil

Although the compressor is supplied with oil, the level may not be correct for the entire

system. Consult the instruction manual of the air conditioning unit for proper levels and

system charging procedures.

Figure 15: Install Serpentine Belt & Tensioner Pulley

Apply anti-seize to the 3/8-16 x 3/4” 12pt. cap screw.

[A] Route serpentine belt as shown below, minus tensioner.

[B] Place a 5/8” box end wrench on tensioner. Align belt onto pulley and pull up until ten-

sioner pulley slips onto tensioner shaft.

Slowly return wrench to starting position to apply tension to belt.

[C] Install the 3/8-16 x 3/4” 12pt. bolt with aluminum washer and tighten firmly. (46 ft/lbs)

WITHOUT POWER STEERING

WITH POWER STEERING

1 2 ... 5 6 7 8 9 10 11

Pas de commentaire

Billet-specialties Premium Tru Trac Serpentine System - Pontiac Manuel d'utilisateur Page 10