Billet-specialties Premium Tru Trac Serpentine System - Pontiac Manuel d'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 11
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
www.billetspecialties.com
www.billetspecialties.com
15
Figure 10: Install AC Compressor
Apply anti-seize to the following:
(1) Compressor shoulder bolt
(2) 8mm-1.25 x 25 12pt. cap screws
[A] Place air compressor between the bridge bracket and the tensioner bracket. Thread
one of the 8mm-1.25 x 25mm 12pt. cap screws through the bridge bracket and into the
bottom boss of the compressor.
[B] Thread the second 8mm-1.25 x 25mm 12pt. cap screw through the bridge bracket and
the top boss of the compressor.
[C] Finish by installing the compressor shoulder bolt through the bottom rear boss of the
compressor and into the compressor bracket.
Figure 9: Install AC Compressor Cover
Apply Loctite Blue 242 to the following:
(3) 1/4-20 x 3/4” socket head cap screws
[A] Place cover on clutch and thread the
socket head cap screws through the cover
and into the clutch, torque to 40-45 inch/lbs.
Caution: Over tightening these festeners will
cause damage to the compressor clutch.
Do Not Over Tighten.
* AT THIS TIME TIGHTEN ALL FASTENERS FIRMLY *
Figure 9: Install Alternator
Apply anti-seize to the following:
(1) 8mm-1.25 x 25mm 12pt. cap screw
(1) 10mm-1.5 x 70mm 12pt. cap screw
[A] Place alternator between the alternator bracket and the bridge bracket, align bottom
holes. Thread the 10mm-1.5 x 70mm 12pt. cap screw through bridge bracket, alternator and
into alternator bracket, finger tighten.
[B] Rotate alternator up to align the top alternator boss with the top bridge bracket ear.
Thread the 8mm 12pt. cap screw through the bridge bracket and into alternator.
Firmly tighten both fasteners.
NOTE: The alternator boss may vary in width due to the polishing process. Check lower
alternator mount boss to see if shims are needed. Included with this kit are .5 & 1mm shim
washers, these shims may or may not be needed.
B
BA
C
A
A
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11

Commentaires sur ces manuels

Pas de commentaire