Billet-specialties Premium Tru Trac Serpentine System - Small Block F Manuel d'utilisateur télécharger pdf (Page 11)

www.billetspecialties.com

Figure 16: Install Alternator

Apply anti-seize to the 10mm-1.5 x 100mm ARP 12pt. bolt. Place alternator

between bridge bracket and timing cover, aligning the bottom alternator

mounting hole with bridge bracket and timing cover.

A] Thread the 10mm-1.5 x 100mm ARP 12pt. bolt through the bridge bracket and

halfway through the alternator. Slide the alternator spacer into position between

the alternator and timing cover. Push bolt through the rest of the way and finger

tighten.

B] Apply anti-seize to the 8mm-1.25 x 25mm ARP 12pt. bolt. Align top alternator

mounting hole with bridge bracket, thread in the 8mm-1.25 x 25mm ARP 12pt.

bolt and tighten firmly.

Figure 17: Complete Bridge Bracket Installation

A] At this time tighten all bridge bracket bolts firmly, leave the bottom alternator

bolt loose and check to see if a shim needs to be added at this time.

The alternator mounting boss may vary in thickness due to the polishing process.

10mm shim washers are provided to shim alternator to bridge bracket (washers

may or may not be needed).

B] Thread the coupler nut onto the coupler spacer and tighten firmly.

1 2 ... 6 7 8 9 10 11 12 13

Pas de commentaire

Billet-specialties Premium Tru Trac Serpentine System - Small Block F Manuel d'utilisateur Page 11