Billet-specialties Tru Trac Serpentine System - LS7 (Top Mount) Manuel d'utilisateur télécharger pdf (Page 8)

www.billetspecialties.com • Tech Line 708.588.0505

LSx Top Mount Tru Trac - 13455 / 13475

Figure 8: Install Alternator

Apply anti seize to the following:

(1) 8mm-1.25 x 25mm ARP 12pt. cap screw

(1) 10mm-1.50 x 70mm ARP 12pt. cap screw

Place alternator between bridge bracket and alternator bracket, align alternator bosses

with the bridge bracket.

[A] Thread the 10mm-1.50 x 70mm ARP 12pt. cap screw through the bottom bridge bracket

hole, alternator, and into the alternator bracket. Finger tighten.

[B] Thread the 8mm-1.25 x 25mm ARP 12pt. cap screw through the bridge bracket and into

the top alternator boss.

Note: 10mm shim washers are provided to shim the alternator if needed at the bottom.

The alternator mounting boss may vary in thickness due to the polishing process.

A A

B B

Figure 9: Install Idler Pulley

Apply anti seize to the 3/8-16 x 2-1/4” ARP 12pt. cap screw.

[A] Place idler pulley bearing sleeve into bearing as shown.

[B] Align Idler pulley and sleeve with bridge bracket and install the 3/8-16 x 2-1/4” ARP 12pt.

cap screw with washer through pulley and bearing sleeve and into bridge bracket. Tighten

firmly.

Tighten ALL fasteners at this time.

All ARP 12pt. fasteners, all flat head bridge bracket screws, 5/16” hex bolt behind tensioner

and compressor shoulder bolt firmly.

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Billet-specialties Tru Trac Serpentine System - LS7 (Top Mount) Manuel d'utilisateur Page 8