Billet-specialties Gas Pedal 199160 Manuel d'utilisateur télécharger pdf

Billet Specialties, Inc. 500 Shawmut Avenue La Grange, Illinois 60526 PH 800.245.5382 Fax 708.588.7181 www.billetspecialties.com

JAN 10

1967 - 1969 Camaro / Firebird

Gas Pedal #199160 / #199165

Tools Needed:

• 5/32” Allen Wrench

• Loc-tite® Thread Locker

• 3/8“ Wrench

• 5/16” drill bit

Other Adjustments Include:

• Gas pedal has two axle pivot options to adjust pedal up and down on arm.

• Lower gas pedal arm can be flipped for added floor clearance.

IMPORTANT

• Check throttle operation before starting vehicle. Gas pedal operation should

be smooth and not bind in any way.

Also required but not included: Throttle cable and housing.

1. Disconnect Battery & throttle linkage arms from carburetor and firewall,

remove and set aside.

2. Remove throttle linkage pivot base from firewall with 3/8” wrench, remove

accelerator pedal from inside of vehicle. Save the fasteners for later use.

3. Install the gas pedal pedestal through the firewall and into the interior of the

vehicle, secure with the two fasteners removed from the pivot base. (It is

recommended to apply a thin bead of RTV Silicone around the pedestal base

to seal out the elements). Tighten firmly.

4. Install the gas pedal components as shown in the illustration and finger tighten.

5. Remove carpet and or insulation from floorboard/firewall that may be in the way

of where the upper arm comes in contact.

6. Remove the clevis and nut from throttle cable (not included) & temporally install

clevis on gas pedal upper arm. Push upper arm with clevis and nut for proper

spacing against firewall and mark position. Find center and drill a small pilot hole

followed by 5/16” bit.

7. Install throttle cable (not included) per manufactures instructions.

8. Adjust gas pedal lower arm angle to your liking and apply Loc-Tite® to the threads

of the flat head cap screw and tighten firmly. Gas pedal should not bind in any

way. Pedal operation should be smooth.

9. Replace carpet and or insulation.

Gas Pedal

Upper Arm

1/4-20 x 1/2”

F.H.C.S.

Aluminum

Washer

Delrin

Bushing

Splined

Bushing

Gas Pedal

Lower Arm

E-Clips

Axle Pivot

Tension Spring

Delrin

Bushing

Gas Pedal

Pedestal

Gas Pedal

Pad

FOR CONVERSION FROM FACTORY THROTTLE LINKAGE TO CABLE STYLE THROTTLE

Shim

Washers

Résumé du contenu

Page 1 - Gas Pedal #199160 / #199165

Billet Specialties, Inc. 500 Shawmut Avenue La Grange, Illinois 60526 PH 800.245.5382 Fax 708.588.7181 www.billetspecialties.comJAN

Modèles reliés Gas Pedal #199165

Commentaires sur ces manuels

Pas de commentaire

Billet-specialties Gas Pedal 199160 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Billet-specialties Gas Pedal 199160. Billet Specialties Gas Pedal 199160 User Manual [en] Manuel d'utilisatio

Résumé du contenu

Modèles reliés Gas Pedal #199165

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture Billet-specialties Gas Pedal 199160