Billet-specialties Premium Tru Trac Serpentine System - Small Block C Manuel d'utilisateur télécharger pdf (Page 8)

www.billetspecialties.com • Tech Line 708.588.0505

Small Block Chevrolet Tru Trac - 13225 / 13125

Figure 14: Install Tensioner Pulley

Apply anti-seize to:

• (1) 3/8-16 x 3/4" 12-point Cap Screw

A] Align the tensioner pulley onto the tensioner's mounting boss. Install the 3/8-16 x 3/4"

12-point cap screw with aluminum load washer as shown. Tighten firmly.

Figure 15: Install Serpentine Belt

With a 5/8" 6-point socket or wrench, turn the belt tensioner release nut clockwise to unload

the spring tension and install the serpentine belt (routing shown below). Slowly return the

tensioner to its starting position to apply tension to the belt.

Figure 12: Install Crank Pulley

Apply anti-seize to:

• (3) 3/8-24 x 1" Socket Head Cap Screws

Using three (3) 3/8-24 x 1" socket head cap

screws with 3/8" Belleville washers align and

install the crankshaft pulley. Cup on washer

should go towards pulley. Torque to 35ft.lbs.

Note: Some crate engines will have a large

center bolt and washer on the damper that

will need to be removed before the pulley

can be installed. This bolt should be replaced

and installed after the pulley with a

7/16-20 x 2-3/4" bolt.

Figure 13: Install Water Pump Pulley

Apply anti-seize to:

• (4) 5/16-24 x 1/2" Socket Head Cap Screws

Align and install the water pump pulley using

four 5/16-24 x 1/2" socket head cap screws.

Tighten firmly.

With Power Steering Without Power Steering

1 2 3 4 5 6 7 8 9

Pas de commentaire

Billet-specialties Premium Tru Trac Serpentine System - Small Block C Manuel d'utilisateur Page 8