Billet-specialties Tru Trac Serpentine System - LS (Top Mount) Manuel d'utilisateur télécharger pdf (Page 5)

www.billetspecialties.com • Tech Line 708.588.0505

LSx Top Mount Tru Trac - 13455 / 13475

Figure 1: Install Water Pump

Apply anti-seize to one end of each of the three 8mm-1.25 x 92mm long threaded studs and

the two 8mm-1.25 x 118mm long studs. Use the two included 8mm-1.25 zinc plated nuts

tightened against each other to act as a drive nut to ease installation if needed.

[A] Thread the three 92mm studs into the passenger side of the engine block, installed height

should be 3” from block.

[B] Follow by threading in the two 118mm studs into the driver side of the engine block,

installed height should be 4” from block.

[C] Slide water pump gaskets over studs, followed by the water pump. Apply anti-seize to the

exposed threads of all the studs.

[D] Thread the three stainless stand-offs with machined groove (1.035") onto the passenger

side of the water pump and finger tighten.

Figure 2: Install Alternator Bracket

[A] Slide the alternator bracket onto the driver side studs. Thread the remaining two short

spacer nuts (1.103") onto the threaded studs and finger tighten.

[B] Finish by threading the 8mm-1.25 x 95mm socket head cap screw through the alternator

bracket and water pump into the engine block. Tighten all fasteners firmly at this time.

A A

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Billet-specialties Tru Trac Serpentine System - LS (Top Mount) Manuel d'utilisateur Page 5