Billet-specialties Premium Tru Trac Serpentine System - 348__409 Chev Manuel d'utilisateur télécharger pdf (Page 5)

www.billetspecialties.com • Tech Line 708.588.0505

348/409 Chevrolet Tru Trac - 14400 / 14420

Figure 3: Install Alternator Bracket

[A] Apply Permatex Hylomar® gasket dressing to both sides of one water pump gasket,

place gasket over driver side water pump studs.

[B] Slide the alternator bracket over the two studs.

With Power Steering

Apply anti-seize to the following

(2) 7/16–14 x 2-1/4” socket head cap screws

[C] Place the power steering bracket on the alternator bracket as shown and thread the two

7/16" socket head cap screws through the power steering bracket, alternator bracket and

into engine block. Tighten firmly.

Without Power Steering

Apply anti-seize to the following:

(2) 7/16-14 x 1-1/2” socket head cap screws

Thread 7/16-14 x 1-1/2” socket head cap screws through the alternator bracket and into

engine block. Tighten firmly, 76 ft.lbs.

Figure 4: Install Water Pump

[A] Apply Permatex Hylomar® gasket dressing to both sides of the remaining water pump

gaskets and install gaskets over studs.

[B] Slide water pump over studs into place.

Apply RTV silicone to the following

(3) 3/8-16 x 2” ARP 12-point cap screws

[C] Remove the passenger side bottom water pump stud and replace with one of the

12-point screws and finger tighten.

[D] Remove the passenger side top water pump stud and replace with one of the 12-point

screws and finger tighten.

[E] Remove the driver side top water pump stud and replace with the final 12-point screw.

Tighten all fasteners firmly, 36 ft.lbs.

Note: Now is a good time to install the 1/2” barbed heater hose fitting on the water pump

(not included with kit).

[A] [A]

[C]

[A]

[D]

[B]

[E]

[B]

[C]

1 2 3 4 5 6 7 8 9 10 11

Pas de commentaire

Billet-specialties Premium Tru Trac Serpentine System - 348__409 Chev Manuel d'utilisateur Page 5