Billet-specialties Premium Tru Trac Serpentine System - Small Block F Manuel d'utilisateur télécharger pdf (Page 8)

www.billetspecialties.com

Figure 9: Complete Water Pump Installation

A] There are now five open holes remaining in the water pump, starting at the

top hole thread the 5/16-18 x 1-1/4” ARP 12pt. bolt and 5/16” flat washer into

hole and finger tighten.

B] Working in a clockwise direction, thread a 5/16-18 x 3” ARP 12pt. bolt and

5/16” flat washer into the next hole and finger tighten.

C] Continuing in a clockwise direction thread a 5/16-18 x 2-1/4” ARP 12pt. bolt

and 5/16” flat washer into the bottom right hole in the water pump and finger

tighten.

D] Thread a 5/16-18 x 1-1/4” ARP 12pt. bolt and 5/16” flat washer into the bottom

left hole in the water pump and finger tighten.

E] Moving on to the remaining hole in the water pump at the top, thread a

5/16-18 x 4-1/4” ARP 12pt. bolt and 5/16” flat washer into the hole and

finger tighten.

Tighten all bolts on the timing cover and then water pump at this time.

Figure 10: Oil Pan Installation (If Removed)

Install oil pan and gasket at this time, thread two 5/16-18 x 1/2" hex head cap

screw through the holes nearest the crankshaft and into the timing cover.

Thread the two remaining 1/4-20 x 1/2" hex head cap screws through the

corner holes of the oil pan into the timing cover.

Tighten all bolts at this time.

Note: Some aftermarket oil pans may require different length hardware.

Figure 10: Oil Pan Installation (If NOT Removed)

Tighten oil pan to motor and timing cover firmly

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Billet-specialties Premium Tru Trac Serpentine System - Small Block F Manuel d'utilisateur Page 8